IPv6: Ready or not?

{ Posted on Jul 21 2009 by Neil Watson }
Tags : ,
Categories : Featured, IPv6, Wholesale

Since 1984 IPv4 (Internet Protocol version 4) addresses which consist of four groupings of numbers (e.g. 123.45.67.89) have been used to access the Internet. Twenty five years on and unsurprisingly the 4.3 billion addresses originally available are now running out with only an estimated 700,000 left. Previous estimates stated IPv4 addresses would be depleted by 2011 or 2012 but a more recent announcement from ARIN (American Registry for Internet Numbers) states this could be as soon as 2010.

neilwatson IPv6: Ready or not?

Neil Watson, Technical Support Manager

The suggested replacement for IPv4 is IPv6 which provides infinitely more IP addresses due to their hexadecimal format, separated by colons e.g. 2ffe:1800:3525:3:200:f8ff:fe21:67cf. This is just as well, as the number of devices we use to access the Internet continues to increase.

Before we run out of IPv4 addresses completely (possibly as soon as next year), we really need to start implementing IPv6 ones. It’s just a matter of getting on and doing it!

It all sounds relatively straightforward, doesn’t it? Well you’d think so. The media and several leading Internet figures have expressed concerns that ISPs’ take up of IPv6 has been too slow and that unless adoption is accelerated we will have consumed all of the available IPv4 addresses before IPv6 is fully supported. In the worst case this would make it impossible for ISPs to accommodate any more subscribers. In reality IPv6 is already available and some ISPs are already utilising it, including Entanet. Whilst several of our competitors may not be implementing IPv6 just yet I find it hard to believe that any would be so negligent that they actually reach this crisis point without taking action. Nevertheless it is possible and if it does happen it will be you and your customers that will be affected.


To encourage adoption the European Community (EC) has set its member states a target of 25% adoption of IPv6 by industry, public authorities and households by 2010 which, if the ARIN estimate is to be believed, could be just in time. This is despite the fact that Europe actually already has the highest take up of IPv6 in the world due to its Internet backbone (GEANT) already being 100% IPv6 compatible.

So why is IPv6 take up so slow? To be able to utilise IPv6 the ISP’s network must be able to support the new addresses. This often requires investment in new and expensive equipment. Despite this being a cost that every network operator is going to have to bare eventually as complete consumption of IPv4 is inevitable, many are using lack of customer demand for IPv6 as their excuse for putting off this investment. Whilst most new hardware available on the market is already IPv6 compatible, the majority connect via existing IPv4 addresses. So is it lack of demand from customers or lack of supply from the providers, that’s the real issue?

The OECD suggests ISPs should consider adoption of IPv6 as a social and commercial opportunity, not a financial burden. I tend to agree. By making IPv6 available, the ISP holds a competitive edge as there are few early adopters within the market. Plus, IPv6 offers additional benefits such as increased security through the use of IPSec. By adopting a ‘wait and see’ approach (which seems even more pointless when the only option to wait for is the inevitable) ISPs are not only missing a competitive opportunity. They are compromising network performance and perhaps even becoming technically negligent. As an early adopter of IPv6, Entanet calls on other ISPs to explain why they are holding off. Just what is it that they are waiting for? What benefits can be obtained (apart from delaying inevitable investment) by adopting a ‘wait until we reach the crisis point’ strategy?

As a reseller (or indeed an end user customer) you will be affected by your provider’s choice of strategy. Ask them what their plans are for IPv6 adoption. Are they already IPv6 compatible and, if not, when are they planning to implement it? Existing IPv4 addresses will be consumed sooner rather than later and you need to make sure your provider has an alternative solution for you and your customers.

Have your say

What do you think about this issue? Are you aware of your ISP’s plans for IPv6? Share your thoughts by leaving us a comment below.

Further Information:


4 Responses to “IPv6: Ready or not?”

  1. From Be* Unlimited: “The short answer is no unfortunately. Later in the year we will be evalauating how to implement IPv6 and will let you know.”

    The apathy towards IPv6 is worrying. The ISPs will have to do the work sooner or later, it’s not as if some miracle is going to occur which will delay the situation. If they do it now they can figure out all the teething problems before all the non-technical users need an IPv6 allocation.

    Sometimes IPv6 just works, other times it’s an absolute pain. If it’s left too late then ISPs will suffer support problems when everyone needs their IPv6 connectivity to work.

  2. Perhaps this article is why some isp’s are reluctant to trust BTw and IPv6 implementation.

    http://www.theregister.co.uk/2008/10/10/21cn_ipv6/
    that is quite old has BT’s stance on the subject changed ????

    As has been proven with the move to WBC and all the problems that has brought, sometimes it is prudent to wait until the major player is willing to support a new system before committing to it.

  3. One of the issues about IPv6 from a server room or end-user viewpoint is that it is rather like the switch from analogue to digital television, or from VHS tape recording to DVD burning. Some of the kit will work on both, but changes or additions are required to utilise the new properly. And once you’ve moved on you can’t then plug back into the old again.

    I recently upgraded the networking kit on one of my sites and thought I had spec’d IPv6 capable kit throughout. It was only afterwards I discovered misleading marketing in that the ADSL router considered “IPv6 capable” as meaning “IPv6 on the internal can be converted to an IPv4 tunnel outside” which is, of course, pretty useless if you wanted native IPv6.

    One also has to consider the major rewrites of code (and database schemas) in moving from v4 to v6 nomenclature. And how many systems are embedded or non-upgradeable? How mission-critical are they? Is it more cost-effective to keep them – at the risk of degraded network performance overall – rather than replace them to take advantage of the IPv6 opportunities.

    It will come, but “when” is a financial decision more than a technical one.

    @AlisonW

  4. Until

    1. a simple low cost home router supports IPv6

    2. XP becomes obsolete

    3. Some killer application exists

    or

    4. IPv4 starts running out (read expensive)

    IPv6 will remain “future technology”.

    ISPs (and companies) are not interested in undertaking the support costs associated with having (or attracting) IPv6 users and staff.

    entanet at least have positioned themselves well, but the online information available to achieve IPv6 to the home is beyond the reach of all but the most technically network minded.

    … I just need to think up the killer application ^^

Post a Comment